Xi'an Tydrillbits Co.,Ltd

Xi'an Tydrillbits Co.,Ltd is one of the most famous China single roller bits manufacturers, welcome to wholesale cheap rock bit from our factory. Single cone bit is a kind of deceleration bit, which is the speed of cone is smaller than the speed of drill, mainly disorderly cutting broken rock. It is suitable for old well sidetracking and deepening the slim hole drilling operation under high rotary speed and drilling pressure.1. Its application field is wide, not only suitable for side drilling, and can be used in deep well.2. Work torque is lower than PDC bit in the same drilling pressure and formation condition. It can reduce the small size hole expansion buckling problems, so that avoid down hole accidents.3. Single cone bit has advantages of both three cone bit and PDC bit, and make up the disadvantages of both. It is more suitable for large plastic formation than three cone bit, also can be applied to hard inter layer which PDC bit can not deal with other complex formation.4. It can realize high speed and special drilling with down hole motor. Size Model in mm 4 1/8 104.8 SD527 SD547 SD617 4 1/2 114.3 SD527 SD547 SD617 4 5/8 117.5 SD527 SD547 SD617 4 7/8 123.8 SD527 SD547 SD617 5 1/2 139.7 SD527 SD547 SD617 6 152.4 SD527 SD547 SD617 6 1/2 165.1 SD527 SD547 SD617 7 1/2 190.5 SD527 SD547 SD617 7 7/8 200.0 SD527 SD547 SD617 8 1/2 215.9 SD527 SD547 SD617 IADC Parameter (Recommended)  Apply to  rock formation (KN/mm) (r/mm) 527 0.3-0.7 120-50 The low strength of the soft stratum,  such as mud stone, gypsum, gypsum,  soft shale, soft limestone 547 0.3-0.7 100-50 Low compressive strength of soft to medium formations,  such as shale, soft soft soft limestone,  sandstone and in with the medium of hard  abrasive inter bedded formation 617 0.4-0.8 90-50 In hard strata with high compressive strength,  such as hard shale, limestone, sandstone, dolomite